App version: 663e83b5e88
© 2024 leddrivinglamps.com All Rights Reserved.Lightforce CBSWR Driving Light Switch and Connector (Ranger PX, BT-50)
Special Price
$33.95
Regular Price
$35.00
In stock
SKU
CBSWR
Lightforce CBSWR Driving Light Switch and Connector (Ranger PX, BT-50) is available to buy in increments of 1
Lightforce CBSWR Driving Light Switch and Connector (Ranger PX, BT-50)
Lightforce CBSWR Driving Light Switch and Connector (Ranger PX, BT-50)
Description
Please note this switch is suitable for the Mazda BT50 (non genuine part) and PX Ranger, but does not fit the new Ford PX2 models. The Ford Ranger PX switch is supplied with the connector and 100mm length harness in blister pack. The connector is also available separately - refer "wiring."
This switch has a maximum current rating of 5 amps @ 12 volts and is to be used in conjunction with a relay. The Lightforce Roo logo illuminates via the dash light circuit, once the switch is pushed on, the upper blue indictor can also be activated.
FEATURES:
- Does not fit the new PX2 models
- Also suitable for the Mazda BT50 (non genuine part)
- This switch has a maximum current rating of 5 amps @ 12 volts and is to be used in conjunction with a relay
- Lightforce Roo logo illuminates via the dash light circuit, once the switch is pushed on, the upper blue indictor can also be activated
SPECIFICATIONS:
- Wiring is as per the following:
- Red - Illuminates the blue indicator on the switch (in the on position) for this to function connect together with the yellow wire
- Blue - 12v in from high beam circuit (connect to brown wire on Lightforce harness)
- Yellow - 12v switched out, connect together with the red wire, then connect to relay {87} (black with red stripe on Lightforce harness)
- Black - Connect to earth circuit (negative)
- Green - From 12v dash light circuit (illuminates Roo logo)
To remove business card holder from vehicle:
- First remove the fuse panel cover located next to the drivers side door, then dislodge the lower trim pannel locaed next to the fuse pannel that has just been removed.
- This will allow you acess to the back of the switch blank (business card holder), apply light presure to the top then the bottom to dislodge from within the dash.
- DO NOT try and remove the switch blank by using a screw driver this will result in damaging the dash surface.
- The connector is also available separately refer wiring
Manufacturer | Lightforce |
---|---|
Barcode | 9335712025104 |
Write Your Own Review